Installation of stone cage net matters needing attention

Authorship:admin;
Time:2019-07-12;
Article reading quantity:;

Step 1: preparation for application of various raw materials

1. The stone cage net in the transportation are packed transportation, so is transported to the construction site, is a number of nets are packed into a large package. Cut and bind the silk, take out the required independent products for installation, with the delivery of products are generally equipped with the silk, we need to cut and fix according to the actual use of the theory.

The special point that needs to be pointed out is that because the product is packed and transported, the volume of the product is compressed by a press when it is packed, and the whole package is relatively compact, so when the wire is cut and tied, the big package will be scattered at once. Be sure to pay attention to personnel safety when opening.

2. The stone cage mesh filled stone should be hard, durable, not broken, the size of the stone should be between 250mm to 75mm, which is usually internationally known as 4-6 inches of stone.

3.stone cage net into the ground before installation, we should be treated foundation, foundation should be flat, dry. The foundation of the wall shall be at an Angle of 1-10 degrees from the ground level to prevent the product from sliding after installation and to ensure the stability of the wall, at least 300mm, at the most front end of the wall. After the installation of the stone cage net behind the slope Angle should also be maintained in a safe Angle, to ensure the stability of the slope.

Step 2: stone cage net assembly and stone filling

1. Open the cage on level ground and smooth it. Attention: wear protective equipment such as goggles and gloves during construction.

2. Stand each side up and combine to form a cage. Each surface of the cage has a thicker edge wire, in the edge of the net to these overlapping edge wire twisted together. These twisted filaments overlap with the filaments at the corners.

3. Tie all surfaces together. Use about 1 meter long binding wire, first binding in one end, and then every 100 mm through the mesh hole, the two adjacent side wire for a single, double winding alternately. In order to ensure the tight connection between the mesh surfaces, the winding should be forced and tightened.

4. If the size of the stone cage mesh box need to be connected together to use (form gabion retaining wall), put the end of the first and the second before the end of the connection, and so on. Place a simple wooden "H" on the inside 1/3 of the height of the last cage and stretch it on the other side until all the cages are stretched and stretched.

The last article：What is the difference between the corrosion resistance of various materials of

The next article：The antisepsis advantage of hook net

* Your Name：
E-mail Address：
* Message Contents：
* Verification image：