What are the advantages of composite steel grid compared with other steel grid?

Authorship:admin;
Time:2019-07-12;
Article reading quantity:;

Compared with patterned steel plate and other grilles, composite steel grille has the following advantages and characteristics:

Material economy: a method of least material consumption under the same load conditions, which correspondingly reduces the material used to support the structure.

Reduce investment: save materials, save labor, save time, save cleaning and maintenance.

The construction is simple: it can be fixed by bolt clamp or welding on the pre-installed support, which can be completed by one person.

Time saving: no site reprocessing, very fast installation.

Durable: after hot dip zinc corrosion treatment before leaving the factory, strong impact and pressure resistance.

Modern style: beautiful appearance, standard design, ventilation and light transmission, give a person the overall smooth modern feeling.

Light structure: less material, light structure, and easy to lift.

Anti - dirt: no rain, snow and dust.

Reduce wind resistance: because of good ventilation, when the wind resistance is small, reduce wind damage.

Simple design: no small beam, simple structure, simple design; There is no need to design the steel grid detailed drawing, just specify the model, the factory can design the layout drawing on behalf of customers.

Good ventilation, daylighting, heat dissipation, explosion-proof, anti-skid performance: acid and alkali corrosion ability: within the range of PH 6 to PH 12.5, the surface of zinc layer forms a stable protective film with good corrosion resistance.

Common specification and fixing method of composite steel grid plate

Composite steel grid plate is also known as steel grid plate, step plate, skid net plate, etc.

Composite steel lattice plate is a kind of product which is composed of steel lattice plate and sealing surface pattern plate, which can be composed of any type of steel lattice plate and different thickness of chemical steel plate. The most commonly used composite steel grid plate specification is g323/40/100 as low plate; Decorative steel plate commonly used 3mm thick plate, can also use 4mm,5mm or 6mm plate.

Method for fixing composite steel lattice plates

The composite steel grid plate can be welded or clamped. The advantage of welding is permanent fixed, not loose, the specific position in each corner of the first flat steel grid plate, weld length is not less than 20mm, height is not less than 3mm fillet welding. The advantage of the installation clip is to destroy the hot dip zinc layer and remove it easily. At least 4 sets of installation clips are required for each board. The number of installation clips increases with the increase of the length of the board. The safest way is to directly weld the screw head on the beam without clamping, to ensure that the steel grid plate will not slip from the beam due to loose clamping.

The last article：Where will the mesh be used?

The next article：Punching mesh products are widely used

* Your Name：
E-mail Address：
* Message Contents：
* Verification image：